This standard is issued under the fixed designation D ; the number 1 This practice is under the jurisdiction of ASTM Committee D on Protective. ASTM D Standard Practice for Surface Cleaning Concrete for Coating. ASTM D (Plastic sheet test): Place plastic sheet on concrete stab for 24 hours. o ASTM-D Standard Practice for Surface Cleaning Concrete for.
|Published (Last):||20 November 2007|
|PDF File Size:||18.64 Mb|
|ePub File Size:||11.42 Mb|
|Price:||Free* [*Free Regsitration Required]|
Need more than one copy? As critical as these steps are, it should come f4258 no surprise that there is a wealth of technical standards available from organizations such as NACEASTMand SSPC which address many aspects of steel and concrete surface preparation.
Wood must be clean and dry. For concrete and steel substrates, a prepared surface is typically one that is clean, dry, structurally sound, and possesses a certain surface profile—the four pillars of good surface preparation. Established by the Steel Structures Council inthese methods are used throughout the world for describing methods for cleaning structural steel. Proper surface preparation can improve the outcome of your coating system.
For exterior surfaces, spackle with exterior grade compounds. As the voice of the U.
Allow the surface to dry thoroughly. High-pressure water blasting is commonly used to clean substrates. Store finishing lumber and flooring in dry, warm rooms to prevent absorption of moisture, shrinkage, and roughening of the wood.
When viewed without magnification, a metallic surface prepared according to this specification should be free of any visible grease, oil, dust, dirt, mill scale, paint, rust, oxides, corrosion products, and other foreign matter.
Staining to be cleaned may consist of light shadows, slight streaks, or minor discolorations caused by stains aetm rust, mill scale, or previously applied paint.
Maintenance painting will frequently not permit or require complete removal of all old coatings prior to repainting. If the document is revised or amended, you will be notified by email.
Prime and paint as soon as possible after surface prep. Spackle the drywall defects.
ASTM D4258 – 05(2017)
If coating aastm is incompatible, complete removal of previous coating s is required per ASTMsee “Concrete Blast Cleaning ” above. Some composition boards may emit a waxy material that must be removed with a solvent prior to coating.
Thorough washing with an abrasive cleanser will clean and dull in one operation, or, wash thoroughly and dull by sanding. Clean off the paste v4258. Allow the coating to dry at least one week before testing for adhesion.
Allow to dry and cure thoroughly for at least 30 days prior to painting. Any existing checked or peeling paint should be scraped and sanded to a sound surface. Surface preparation methods as outlined in ASTM D are required if the coating system is incompatible. Rinse with clear water and allow to dry.
Standard – Standard Practice for Surface Cleaning Concrete for Coating ASTM D –
Here is a summary of some of the published standards with which installers and specifiers of corrosion protection linings should be familiar. Hand Tool Cleaning will remove all loose rust, loose mill scale, and other undesired foreign matter. Rags and cleaning solution should be changed frequently so that deposits of oil and grease are not spread over additional areas in the cleaning process.
The subject of surface preparation leads me to recall my own home interior painting projects. Treat textured, soft, porous, or powdery plaster with a solution of 1 pint household vinegar to 1 gallon of water.
Please first verify your email before subscribing to alerts. Rinse carefully and allow to dry. So many corrosion protection lining projects succeed or fail with the quality of the surface preparation achieved before the lining is even installed.
All loose rust, loose mill scale, loose and other detrimental foreign matter can zstm removed by power tool cleaning. Make sure all spackled nail heads and tape joints are sanded smooth and all dust removed prior to x4258. Profiled Increasing the surface area of the substrate by imparting a profile with some tooth gives lining systems more to grab on to.